Hi everyone ,
I am trying to set up a stepper motor to run with a V350-35-T2, but I am pretty sure I have it set up incorrectly. Can someone guide me a bit? I am using a DM542 driver (https://www.oyostepper.com/goods-12...20-50VDC-for-Nema-17-23-24-Stepper-Motor.html) and it is driving a SST59D5255. I have connected the PLC and the driver, and have the HSO set up.
When MB0 (Run MB) activates, there is a 0.3V drop on O0, and DW0 (current position) increments until it reaches DW1 (target), at which point it loops back to zero. There are no observable changes elsewhere, and no change in voltage from the driver to the motor.
As I mentioned, I highly doubt that my wiring is incorrect. I have not been able to find guidance on this issue in the installation documentation, programming guides, or online forums. Can anyone point me in the right direction? Thanks in advance!
I am trying to set up a stepper motor to run with a V350-35-T2, but I am pretty sure I have it set up incorrectly. Can someone guide me a bit? I am using a DM542 driver (https://www.oyostepper.com/goods-12...20-50VDC-for-Nema-17-23-24-Stepper-Motor.html) and it is driving a SST59D5255. I have connected the PLC and the driver, and have the HSO set up.
When MB0 (Run MB) activates, there is a 0.3V drop on O0, and DW0 (current position) increments until it reaches DW1 (target), at which point it loops back to zero. There are no observable changes elsewhere, and no change in voltage from the driver to the motor.
As I mentioned, I highly doubt that my wiring is incorrect. I have not been able to find guidance on this issue in the installation documentation, programming guides, or online forums. Can anyone point me in the right direction? Thanks in advance!